Boiler Installations & Replacements in Filton, sized for your home
Gas Safe engineers fitting new boilers in Filton's interwar semis, post-war estates and newer homes, with a free quote before any work is booked.
- 10 years trading
- Gas Safe
- Local to Bristol
Why so many Filton boilers are due a replacement
Filton grew quickly around the aircraft works, and a lot of the housing reflects that. Interwar and post-war semis and terraces sit alongside later estates and newer homes on the old airfield side. Plenty of these houses have had a boiler swapped once or twice, often with the original pipework and radiators left as they were.
That is usually where the trouble starts. An older boiler sitting on a system full of sludge works harder every winter. Bristol's hard water adds limescale to the mix, which hits heat exchangers and small waterways in combi boilers especially.
A replacement here is rarely just a like-for-like swap. Semis and terraces often have the boiler in a kitchen or garage with the flue close to a neighbour's boundary, so the flue route needs checking against the manufacturer's instructions and the regulations. The condensate pipe also needs a safe route to a drain, and it needs insulating if it runs outside, so it doesn't freeze in a cold snap.
The cost depends on a few practical things:
- Whether you stay with your current boiler type or switch between combi, system and regular - The output your house needs, based on its size and heat loss rather than a guess - Whether the boiler stays where it is or moves, which changes pipework, flue and condensate routes - The condition of the existing system, and whether it needs a clean or new components - Controls, such as a smart thermostat, and radiator valves
- Boiler over 10 to 15 years old and breaking down more often
- Radiators cold at the bottom, or the system noisy and slow to warm up
- Pilot or ignition faults, or pressure that keeps dropping
- Heating bills creeping up with no change in how you use it
What happens from the survey to the first hot shower
Whether you're near Filton Avenue, Northville or the newer streets by the old airfield, the job follows the same sequence.
- 1
A survey at your house, and a free quote
We look at where the boiler is, how the flue and condensate pipe could run, how your system is piped and how you use hot water. You get a written quote with the options explained in plain English.
- 2
Choosing the right boiler and agreeing the plan
We help you match boiler type and output to your home, not to the most expensive box on the shelf. We also agree the day, how long the heating and hot water will be off, and where we can park.
- 3
Fitting day: out with the old, in with the new
We isolate and drain the system, remove the old boiler and fit the new one with a magnetic filter. The system is flushed and treated with inhibitor, and the flue and condensate run are fitted to regulations. Controls are connected and floors and walls are protected throughout.
- 4
Commissioning, handover and paperwork
We test the boiler, check gas tightness and combustion, and complete the commissioning checklist. We show you how the controls work, and the installation is notified under Building Regulations through our Gas Safe registration.
Qualified, covered and clear on cost
- Gas Safe registered engineers on every boiler installation
- Fully insured for the work in your home
- A free quote before you commit to anything
- Honest advice, including when a repair makes more sense than a replacement
What customers near Filton say
Brilliant service from start to finish. Our boiler stopped working and the team came out quickly, diagnosed the problem and had everything sorted. Really friendly and professional.
Excellent experience. Turned up on time, explained everything clearly and the pricing was exactly as quoted. Would definitely recommend PlumbTap.
Used PlumbTap for a leaking pipe and some central heating repairs. Quick response, great workmanship and no messing around. Will definitely use them again.
Replacing a boiler in Filton: your questions
Do you cover all of Filton and the streets around it?
Yes. We work across Filton and the neighbouring parts of north Bristol. If you're not sure we cover your road, call 01225 123456 and we'll tell you.
How long does a boiler replacement take?
A like-for-like swap is often done in a day or so. Moving the boiler, changing from a regular to a combi, or cleaning a sludged-up system takes longer. We'll tell you what to expect when we quote.
My boiler is in a semi with the flue close to next door. Is that a problem?
Not necessarily, but the flue terminal has to meet the manufacturer's clearances and the regulations. We check this at the survey, and if the current position won't work we'll explain the alternatives.
Should I upgrade my radiators or controls at the same time?
Not always, but it's worth looking at. A new boiler on a sludged-up system won't perform properly, so we check the system's condition. Modern controls such as a programmable or smart thermostat can help the boiler run more efficiently.
Will you tell me if I don't need a new boiler?
Yes. If a repair makes sense, we'll say so. A free quote means you can compare the options before deciding.
Is the installation registered, and will I get paperwork?
Yes. Our Gas Safe registered engineers notify the installation under Building Regulations and complete the commissioning record. You get the paperwork for your records and for any future sale of the house.
Thinking about a new boiler for your Filton home?
Call 01225 123456 to book your free quote. We're available Monday to Friday 9-6 and Saturday 9-4.